COMBINATION METER REMOVAL


  1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 2


    1. A003CW2

      Using a moulding remover D, detach the 3 claws and remove the instrument cluster finish panel garnish No. 2.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER


    1. for Standard Body:

      Using a moulding remover D, detach the 4 claws in the order shown in the illustration.

    2. for Wide Body:

      Using a moulding remover D, detach the 5 claws in the order shown in the illustration.

      A003EYOE01
      Text in Illustration
      *A for Standard Body *B for Wide Body
    3. A003HF9E01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape as shown in the illustration.

    4. Using a moulding remover D, detach the claw.

    5. A003HIA

      Detach the claw as shown in the illustration.

    6. A003F1Y

      Detach the 3 claws as shown in the illustration.

    7. A003EPO

      Detach the 2 claws as shown in the illustration.

    8. for Standard Body:

      Detach the 3 claws and remove the instrument cluster finish panel sub-assembly center.

    9. for Wide Body:

      Detach the 4 claws and remove the instrument cluster finish panel sub-assembly center.

      A003C18E01
      Text in Illustration
      *A for Standard Body *B for Wide Body
  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 1


    1. A003AP6

      Using a moulding remover D, detach the 3 claws and remove the instrument cluster finish panel garnish No. 1.

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A003B9W

      Using a moulding remover D, detach the 4 claws and remove the instrument cluster finish panel assembly.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A003GUO

      Detach the 6 claws and 4 hooks and remove the instrument cluster finish panel sub-assembly.

  6. REMOVE COMBINATION METER ASSEMBLY


    1. A003GSD

      Remove the 2 screws.

    2. A003CO3

      Detach the 2 claws and remove the combination meter assembly.

    3. Disconnect the 2 connectors and detach the wire harness clamp.