REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR


    1. A003G0RE01

      Install the grommet as shown in the illustration.

    2. A003G2GE01

      Install the rear wiper motor with the 3 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Install the clamp and connect the connector.

  2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY UPPER


    1. A003FV5E01

      Attach the 6 clips to install the upper back door trim board assembly.

  3. INSTALL REAR NO.1 WIPER LINK PIVOT WASHER


    1. A003AX6E02

      Install the rear No.1 wiper link pivot washer from the outside of the vehicle with the installation mark at the top.

    2. A003H5E

      Using the socket wrench (27 mm), install the lock nut.

      Torque:
      12 N*m  { 120 kgf*cm, 9 ft.*lbf }

      Note

      Do not damage the glass.

  4. INSTALL REAR WIPER SHAFT COVER

  5. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. A003IDLE03

      Operate the wiper, and stop the rear wiper motor at the automatic stop position.

    2. Clean the wiper arm serrations.

    3. Clean the wiper pivot serrations with a wire brush (when reinstalling).

    4. A003BLKE01

      Install the rear wiper arm and blade assembly with the nut at the position as shown in the illustration.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

      Tech Tips

      Hold the arm hinge by hand to fasten the nut.

    5. Operate the rear wiper while spraying water or washer fluid on the windshield. Make sure that the wipers function properly and there is no interference with the vehicle body.