SEAT BELT WARNING SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data List.

    5. According to the display on the GTS, read the Data List.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      P-Seatbellt Buckle SW* Front passenger side seat belt buckle signal / ON or OFF

      ON: Front passenger side seat belt unfastened

      OFF: Front passenger side seat belt fastened

      		 Perform the inspection while sitting in the front passenger side seat.
      Driver Side Seatbelt Buckle Switch Driver side seat belt buckle signal / ON or OFF

      ON: Driver side seat belt unfastened

      OFF: Driver side seat belt fastened

      		 -

      • *: w/ Front Passenger Seat Belt Warning System

  2. ACTIVE TEST

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. According to display on the GTS, perform the Active Test.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Front Passenger Side Seat Belt* Front passenger side seat belt warning light OFF/ON Confirm that the vehicle is stopped and the engine is idling.
      Driver Side Seat Belt Driver side seat belt warning light OFF/ON Confirm that the vehicle is stopped and the engine is idling.

      • *: w/ Front Passenger Seat Belt Warning System