MAGNET VALVE INSPECTION


  1. INSPECT MAGNET VALVE

    A003F4JE01
    Text in Illustration
    *a

    Component without harness connected

    (Magnet Valve)

    1. Inspect the operation of the magnet valve.


      1. Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2 and check that an operating noise can be heard.

        If the result is not as specified, replace the magnet valve.

    2. Inspect the resistance of the magnet valve.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 13.4 to 15.6 Ω

        If the result is not as specified, replace the magnet valve.