PARKING BRAKE LEVER DISASSEMBLY


  1. REMOVE PARKING BRAKE CABLE ASSEMBLY NO.1


    1. A003E0M

      Remove the parking brake plunger protector.

    2. A003CUC

      Remove the clip.

    3. A003C2R

      Remove the clip from the parking brake wire hole pin.

    4. A003EMB

      Remove the parking brake wire hole pin and the parking brake wire pulley.

    5. A003GBLE01

      Remove the parking brake switch assembly.

    6. A003ETWE01

      Move the parking brake pawl (A) to release the lock, and push in the parking brake plunger assembly (B) as shown in the illustration.

    7. A003FWD

      Separate the parking brake cable assembly No.1 from the parking brake plunger assembly.

    8. A003AX9

      Remove the parking brake cable assembly No.1 from the bracket.

  2. REMOVE PARKING BRAKE PLUNGER ASSEMBLY


    1. A003DLZ

      Using a punch (φ3 mm) and hammer, remove the parking brake plunger pin.

    2. A003AZQ

      Using a small screwdriver, remove the parking brake plunger anti-rattle.

      Tech Tips


      • Turn the parking brake anti-rattle, and remove it from its end.

      • Tape up the screwdriver tip before use.

    3. Remove the parking brake plunger assembly from the parking brake plunger guide.

    4. A003DHU

      Using a small screwdriver, remove the parking brake plunger bushing.

      Note

      Do not damage the plunger guide.

      Tech Tips

      Tape up the screwdriver tip before use.

    5. A003B0C

      Using a drill (φ4mm), remove the staking part of the parking brake pawl pin.

      Note

      Do not damage the plunger guide.

    6. Remove the 2 parking brake pawl pins, 2 parking brake pawls and 2 springs.