VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light does not Come ON

DESCRIPTION

Refer to Slip Indicator Light Remains ON Click here.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Click here.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

   
   

   1. Check if CAN communication system DTCs are output Click here.

      Result
      Result Proceed to DTC is not output A DTC is output B

   
   

   B

   CHECK CAN COMMUNICATION SYSTEM Click here

   A

2. PERFORM ACTIVE TEST USING GTS (SLIP INDICATOR LIGHT)

   
   

   1. Turn the ignition switch off.

   2. Connect the GTS to the DLC3.

   3. Turn the ignition switch to ON.

   4. Turn the GTS on.

   5. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

   6. According to the display on the GTS, perform the Active Test.

      ABS/VSC/TRC

      Tester Display	Test Part	Control Range	Diagnostic Note
      Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter assembly Vehicle condition: Vehicle stopped

   7. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List.

      ABS/VSC/TRC

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Slip Indicator Light	Slip Indicator Light / ON or OFF	ON: Indicator light on OFF: Indicator light off	-

      Result
      Result Proceed to Slip indicator light in the Data List turns ON/OFF using the Active Test A Slip indicator light in the Data List does not change using the Active Test B

   
   

   B

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   A

3. INSPECT COMBINATION METER ASSEMBLY

   
   

   1. Turn the ignition switch off.

   2. Perform Active Test of the combination meter assembly using the GTS Click here.

   3. Check the combination meter assembly.

      OK
      The slip indicator light turns on or off in accordance with the GTS.

   
   

   NG

   INSPECT METER / GAUGE SYSTEM Click here

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here