VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1428

DTC Code DTC Name
C1428 Motor Circuit Malfunction

DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
C1428 With the motor relay and motor fail-safe relay OFF, open or short in motor circuit continues for 2 seconds or more. Brake actuator assembly (Motor circuit)

WIRING DIAGRAM

Refer to DTCs C142B, C146C and C146D Click here.

INSPECTION PROCEDURE

Note


  • When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)


    1. A003DRZE05
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Skid Control ECU (Brake Actuator Assembly))

      Turn the ignition switch off.

    2. Make sure that there is no looseness at the locking part and the connecting part of the connectors.

    3. Disconnect the B92 skid control ECU (brake actuator assembly) connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      B92-1 (GND2) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)

    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here