TIRE PRESSURE WARNING RESET SWITCH INSPECTION


  1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    1. A003BSLE01
      Text in Illustration
      *a

      Component without harness connected

      (Tire Pressure Warning Reset Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 - 6 Tire pressure warning reset switch pressed Below 1 Ω
      Tire pressure warning reset switch not pressed 10 kΩ or higher

      If the result is not as specified, replace the tire pressure warning reset switch.

    2. A003GA2E01
      Text in Illustration
      *a

      Component without harness connected

      (Tire Pressure Warning Reset Switch)
      *b Tire Pressure Warning Reset Switch Illumination

      Apply battery voltage between the terminals of the tire pressure warning reset switch, and check the illumination condition.

      Standard
      Measurement Condition Switch Condition

      Battery positive (+) → 5 (ILL+)

      Battery negative (-) → 4 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the tire pressure warning reset switch.