PROPELLER SHAFT ASSEMBLY (for Super Long Wheelbase) INSTALLATION


  1. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


    1. A003BT1E01

      Remove the SST from the extension housing.

    2. Install the propeller with center bearing shaft assembly in the extension housing.

    3. A003C3U

      Install the center support bearing assembly No.1, and temporarily tighten the 2 bolts.

    4. A003AD9E01

      Align the matchmarks on the propeller shaft flange and differential flange.

    5. Install the propeller shaft assembly with the 4 nuts, 4 bolts and 4 washers.

      Torque:
      74 N*m  { 755 kgf*cm, 54 ft.*lbf }
    6. A003CNLE01

      Check that the center line of the bracket is at right angles to the shaft axial direction.

    7. A003IAIE01

      Adjust the center support bearing assembly No.1.

      Tech Tips


      • With the vehicle unladen, adjust the center support bearing No.1 to maintain the angles, as shown.

      • In the same conditions, check the center line in the axial direction. Adjust the bearing if necessary.

      • The center bearing center line and center bearing housing center line must be adjusted to within -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) of each other in the vehicle's longitudinal direction with the vehicle unladen.

    8. Tighten the 2 bolts.

      Torque:
      36 N*m  { 369 kgf*cm, 27 ft.*lbf }