PROPELLER SHAFT ASSEMBLY (for Long Wheelbase) DISASSEMBLY


  1. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY


    1. A003ED0E01

      Put matchmarks on the flange yoke and propeller shaft assembly.

    2. A003I5Q

      Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

    3. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

    4. Hold the propeller shaft assembly in a vise between aluminium plates.

      Note

      Do not overtighten the vise.

    5. A003CKBE01

      Using SST, push out the spider bearing from the propeller shaft.

      SST
      09332-25010

      Tech Tips

      Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.

    6. A003BAVE01

      Clamp the spider bearing outer race in a vise between aluminium plates and tap off the propeller shaft with a hammer.

      Note


      • Do not overtighten the vise.

      • Do not tap the shaft.

      Tech Tips

      Remove the spider bearing on the opposite side using the same procedure.

    7. Install the 2 removed spider bearing outer races to the spider.

    8. Hold the flange yoke in a vise between aluminium plates.

      Note

      Do not overtighten the vise.

    9. A003BBBE01

      Using SST, push out the spider bearing from the flange yoke.

      SST
      09332-25010

      Tech Tips

      Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.

    10. A003GKME01

      Clamp the spider bearing outer race in a vise between aluminium plates and tap off the propeller shaft with a hammer.

      Note


      • Do not overtighten the vise.

      • Do not damage the flange yoke.

    11. Remove the universal joint spider.

      Tech Tips

      Remove the spider bearing on the opposite side using the same procedure.