SHIFT AND SELECT LEVER SHAFT ASSEMBLY DISASSEMBLY


  1. REMOVE SELECT OUTER LEVER LOCK PIN


    1. A003CK9

      Loosen the nut of the select outer lever lock pin until the top of the nut becomes flush with the end of the lock pin.

    2. A003ECR

      Using a brass bar and a hammer, disengage the select outer lever lock pin.

    3. Remove the nut, washer and select outer lever lock pin from the shift lever shaft housing assembly.

  2. REMOVE SELECT OUTER LEVER


    1. A003ERE

      Remove the select outer lever and washer from the select lever shaft sub-assembly.

  3. REMOVE SELECT LEVER SHAFT SUB-ASSEMBLY


    1. A003AO4

      Remove the select lever shaft sub-assembly from the shift lever shaft housing.

  4. REMOVE LEVER LOCK PIN NO.2


    1. A003EAX

      Loosen the nut of the lever lock pin No.2 until the top of the nut becomes flush with the end of the lock pin.

    2. A003ALQ

      Using a brass bar and a hammer, disengage the lever lock pin No.2.

    3. Remove the nut, washer and lever lock pin No.2 from the shift lever shaft housing assembly.

  5. REMOVE SHIFT OUTER LEVER NO.1


    1. A003CAA

      Remove the shift outer lever No.1 from the shift and select lever shaft.

  6. REMOVE SHIFT LEVER BOOT


    1. A003EUJ

      Remove the shift lever boot from the shift lever shaft housing.

  7. REMOVE SHIFT AND SELECT LEVER SHAFT


    1. A003G83

      Using a pin punch (5 mm) and a hammer, remove the shift lever shaft set slotted pin.

      Note

      Be careful not to damage the shift and select lever.

    2. A003AONE01

      Pull out the shift and select lever shaft from the shift lever shaft housing.

  8. REMOVE SHIFT AND SELECT LEVER


    1. A003CA2

      Remove the shift and select lever, select spring seat No.1 and spring from the shift lever shaft housing.

  9. REMOVE REVERSE RESTRICT PIN SLOTTED SPRING PIN


    1. A003B0U

      Using a hammer, drive a screw extractor into the reverse restrict pin slotted spring pin.

    2. Pull out the reverse restrict pin slotted spring pin from the shift lever shaft housing.

  10. REMOVE REVERSE RESTRICT PIN NO.1


    1. A003FE7

      Remove the reverse restrict pin No.1 and compression spring from the shift lever shaft housing.

    2. Remove the compression spring from the reverse restrict pin No.1.

  11. REMOVE SHIFT LEVER NO.2 SHAFT OIL SEAL


    1. A003F7F

      Using a screwdriver with its tip taped, remove the shift lever No.2 shaft oil seal from the shift lever shaft housing.

      Note

      Be careful not to damage the shift lever shaft housing.

  12. REMOVE SHIFT LEVER SHAFT OIL SEAL


    1. A003AQH

      Using a screwdriver with its tip taped, remove the shift lever shaft oil seal from the shift lever shaft housing.

      Note

      Be careful not to damage the shift lever shaft housing.