PARK / NEUTRAL POSITION SWITCH INSTALLATION


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A003EYH

      Temporarily tighten the park/neutral position switch assembly with the bolt.

    2. A003BC0E01

      Install the nut stopper and the lock nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    3. A003I04E02

      Turn the control shaft lever to a clockwise until it stops, and turn it counter clockwise until 2 notches to set it to the N position.

    4. A003GE4E02

      Align the neutral basic line with the switch groove and tighten the adjusting bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 10 ft.*lbf }
    5. A003CCSE02

      Using screw driver, bend the tabs of nut stopper.

    6. A003I79E02

      Connect the connector of park/neutral position switch assembly.

    7. A003CDDE02

      Install the heat insulator to the park/neutral position switch assembly with 2 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 61 in.*lbf }

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A003GA5E05

      Fix the control cable with a new clip to the control cable bracket.

    2. Install the control cable to the control shaft lever with a nut.

      Torque:
      15 N*m  { 150 kgf*cm, 11 ft.*lbf }

  3. CONNECT BATTERY NEGATIVE CABLE

  4. INSPECT SHIFT LEVER POSITION


    1. When shifting from P position only with ignition switch ON and depress the break pedal.

    2. Make sure that the shifting lever moves smoothly and can be moderately operated.

    3. When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves reward when shifting R position.

  5. ADJUST SHIFT LEVER POSITION


    1. A003CCGE02

      Remove a clip, nut, and disconnect between the control shaft lever to transmission control cable assembly from the control shaft lever and transmission control cable bracket No.1.

    2. A003HNXE05

      Turn the control shaft lever until stop to a clockwise direction, return the control shaft lever 2 notches to N position.

    3. A003HJP

      Set the shift lever to N position while holding the shift lever lightly toward the R position side and install it.

      Torque:
      15 N*m  { 150 kgf*cm, 11 ft.*lbf }

      Note

      Tighten the nut with it closing up cranky.

    4. Inspect the operation condition and work.

  6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Apply the parking break and turn ignition switch on.

    2. Depress the break pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.

    3. Check that the back up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function.

    4. If a failure is found, check the park/neutral position switch for continuity.

  7. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A003GE4E01

      Move the shift lever to the N position.

    2. Loosen the bolt of the park/neutral position switch.

    3. Align the groove and the neutral basic line.

    4. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 10 ft.*lbf }

    5. After adjustment, perform the inspection.

  8. PERFORM INITIALIZATION

    Click here