VALVE BODY ASSEMBLY INSTALLATION


  1. INSTALL SHIFT SOLENOID VALVE


    1. Install the shift solenoid valve SLT and solenoid lock plate with the bolt.

      Torque:
      6.4 N*m  { 65 kgf*cm, 56 in.*lbf }
      A003D5TE01
      Text in Illustration
      *A w/ Flex Lock-up *B w/o Flex Lock-up
      *1 Shift Solenoid Valve S1 *2 Shift Solenoid Valve S2
      *3 Temperature Sensor Clamp *4 Solenoid Clamp
      *5 Shift Solenoid Valve SLU *6 Shift Solenoid Valve SL
      *7 Solenoid Lock Plate *8 Shift Solenoid Valve SLT

    2. w/o Flex Lock-up:


      1. Coat a new O-ring with ATF and install it to the shift solenoid valve SL.

      2. Install the shift solenoid valve SL with the bolt.

        Torque:
        9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. w/ Flex Lock-up:


      1. Install the solenoid clamp and shift solenoid valve SLU with the bolt.

        Torque:
        6.6 N*m  { 67 kgf*cm, 59 in.*lbf }

      2. Install the temperature sensor clamp with the bolt.

        Torque:
        9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Coat a new O-ring with ATF and install it to the shift solenoid valve S2.

    5. Coat a new O-ring with ATF and install it to the shift solenoid valve S1.

    6. Install the shift solenoid valve S2 and shift solenoid valve S1 with the bolt.

      Torque:
      6.6 N*m  { 67 kgf*cm, 59 in.*lbf }

  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


    1. A003HDHE01

      Align the groove of the manual valve with the pin of the lever.

    2. A003I22E02

      Install the 20 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }
      Bolt length
      Bolt A
      23 mm (0.91 in.)
      Bolt B
      28 mm (1.10 in.)
      Bolt C
      36 mm (1.42 in.)

  3. CONNECT TRANSMISSION WIRE

    Click here

  4. ADD AUTOMATIC TRANSMISSION FLUID

  5. INSPECT AUTOMATIC TRANSMISSION FLUID

    Tech Tips

    Drive the vehicle so that the engine and transmission are at normal operating temperature.

    Fluid temperature
    70 to 80 °C (158 to 176 °F)

    1. A003EB4E01

      Park the vehicle on a level surface and set the parking brake.

    2. With the engine idling and the brake pedal depressed, move shift the lever into all positions from P to L and return to the P position.

    3. Take out the dipstick and wipe it clean.

    4. Put it back all the way.

    5. Take it out again and check that the fluid level is within the HOT range.

      If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.

  6. PERFORM INITIALIZATION

    Click here