TRANSMISSION WIRE INSTALLATION


  1. INSTALL TRANSMISSION WIRE


    1. A003EXHE01

      Coat a new O-ring with ATF and install it to the transmission wire.

    2. A003GMB

      Install the transmission wire with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  2. CONNECT TRANSMISSION WIRE


    1. A003F43

      Connect the ATF temperature sensor connector and shift solenoid valve connectors.

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


    1. A003AUNE03

      Install 3 new gaskets.

    2. Install the oil strainer with the 4 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }
      Bolt length
      Bolt A
      14 mm (0.55 in.)
      Bolt B
      20 mm (0.79 in.)
      Bolt C
      23 mm (0.91 in.)

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A003HRJE02

      Install the 3 magnets in the indications of the oil pan sub-assembly.

    2. Remove any packing material and be careful not to drop oil on the contacting surfaces of the transmission case and oil pan sub-assembly .

      Note

      Apply seal packing to the contact surface and install the oil pan with in 10 minutes of application.

    3. A003EJ4

      Apply FIPG to the oil pan, as shown in the illustration.

      FIPG
      Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent
    4. A003H9X

      Uniformly tighten the 19 bolts in several times and install the transmission oil pan.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }

  5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    1. A003D9DE01

      Coat a new O-ring with ATF, and install it to the oil filler tube.

    2. Install the oil filler tube to the automatic transmission with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. ADD AUTOMATIC TRANSMISSION FLUID

  8. INSPECT AUTOMATIC TRANSMISSION FLUID

    Tech Tips

    Drive the vehicle so that the engine and transmission are at normal operating temperature.

    Fluid temperature
    70 to 80 °C (158 to 176 °F)

    1. A003EB4E01

      Park the vehicle on a level surface and set the parking brake.

    2. With the engine idling and the brake pedal depressed, move shift the lever into all positions from P to L and return to the P position.

    3. Take out the dipstick and wipe it clean.

    4. Put it back all the way.

    5. Take it out again and check that the fluid level is within the HOT range.

      If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.

  9. PERFORM INITIALIZATION

    Click here