ATF TEMPERATURE SENSOR INSTALLATION


  1. INSTALL ATF TEMPERATURE SENSOR


    1. Coat the O-ring of the ATF temperature sensor with ATF.

    2. Using a 19 mm union nut wrench, install the ATF temperature sensor.

      Torque:
      15 N*m  { 150 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    3. Connect the connector.

  2. CHECK AUTOMATIC TRANSMISSION FLUID LEVEL

    Click here