POWER SLIDE DOOR TOUCH SENSOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE SLIDE DOOR WINDOW GARNISH LH


    1. A003GFE

      Disengage the 4 clips and remove the slide door window garnish.

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A003DV1

      Using "TORX" socket wrench T25, remove the 2 screws.

    2. A003EWN

      Disengage the claw and 19 clips, and remove the rear door trim board.

  4. REMOVE REAR DOOR SCUFF PLATE LH


    1. A003C68

      Disengage the claw and 12 clips.

    2. Disconnect the connector and remove the rear door scuff plate.

  5. REMOVE SIDE STEP REAR SUPPORT LH

    A003I70

    1. Remove the 3 bolts and the side step rear support.

  6. REMOVE DOOR CONTROL RELAY ASSEMBLY

    A003GIX

    1. Disconnect the connectors.

    2. Remove the bolt and the door control relay.

  7. REMOVE REAR NO. 2 DOOR WIRE


    1. A003EH0

      Remove the bolt.

    2. A003CD3

      Disconnect the connector from the vehicle.

    3. A003ALV

      Remove the 4 bolts, and then disengage the 4 clips.

    4. Disconnect the connector of the door, and remove the rear No. 2 door wire.

      Note

      Do not put anything on the rear No. 2 door wire after removal.

  8. REMOVE SLIDE DOOR SERVICE HOLE COVER LH


    1. A003BGZ

      Disengage the clamp.

    2. Disconnect the cable from the slide door lock remote control.

    3. Remove the slide door service hole cover.

  9. REMOVE POWER SLIDE DOOR TOUCH SENSOR

    A003DY6

    1. Disconnect the connector.

    2. Using "TORX" socket wrench T25, remove the 6 screws.

    3. Remove the 3 bolts.

    4. Disengage the 2 clips and the power slide door touch sensor.