SLIDE DOOR LOCK RELEASE MOTOR INSTALLATION


  1. INSTALL SLIDE DOOR LOCK RELEASE MOTOR

    A003C4V

    1. Install the slide door lock release motor with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the link.

    3. Connect the connector and cable.

  2. INSTALL SLIDE DOOR SERVICE HOLE COVER LH

    A003CSH

    1. Apply butyl tape to the door panel, then install a new slide door service hole cover as shown in the illustration.

      Tech Tips


      • When installing the service hole cover, pull the links and connectors out through the service hole.

      • There should be no wrinkles or folds after attaching the service hole cover.

      • After attaching the service hole cover, check the quality of the seal.

    2. Connect the cable to the slide door lock remote control.

    3. Engage the clamp.

  3. INSTALL REAR NO. 2 DOOR WIRE


    1. A003ALV

      Engage the 4 clips and install the rear No. 2 door wire.

      Note

      Engage the clips by directly pushing them in by hand, not by tapping on the case surface.

    2. Tighten the 4 bolts.

      Note

      Do not tighten the bolts with any wire harness or cable wedged under the case as it may cause the case to deform or malfunction.

    3. A003EPL

      Make sure that the wire harness is not twisted, and tighten the bolts after the clamp is fully secured by turning it in the direction indicated by the arrow mark.

    4. Connect the connector.

  4. INSTALL DOOR CONTROL RELAY ASSEMBLY

    A003GIX

    1. Install the door control relay with the bolt.

    2. Connect the connectors.

  5. INSTALL SIDE STEP REAR SUPPORT LH

    A003I70

    1. Install the side step rear support with the 3 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  6. INSTALL REAR DOOR SCUFF PLATE LH


    1. A003C68

      Connect the connector.

    2. Engage the claw and 12 clips and install the rear door scuff plate.

  7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A003EWN

      Engage the claw and 19 clips, and install the rear door trim board.

    2. A003DV1

      Using "TORX" socket wrench T25, tighten the 2 screws.

  8. INSTALL SLIDE DOOR WINDOW GARNISH LH


    1. A003GFE

      Engage the 4 clips and install the slide door window garnish.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }