REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. Apply MP grease to a new rear crankshaft oil seal lip.

      Note

      Keep the lip free from foreign matter.

    2. A003HDVE02

      Using SST and a hammer, tap in the rear crankshaft oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note

      Wipe off extra grease from the crankshaft.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A003EKJE01

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    2. A003FM5E01
      Text in Illustration
      *1 Front Drive Plate Spacer (Reversible)
      *2 Drive Plate and Ring Gear Sub-assembly
      *3 Rear Drive Plate Spacer
      A003DCD Transmission Side
      A003GWQ Engine Side

      Install the front drive plate spacer, drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

      Tech Tips


      • The front drive plate spacer is reversible.

      • As the rear drive plate spacer and drive plate and ring gear sub-assembly are not reversible, be sure to install it so that it is facing in the direction shown in the illustration.

    3. Clean the bolts and bolt holes.

    4. Apply adhesive to 2 or 3 threads at the end of each of the 10 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    5. A003D1DE01

      Install and uniformly tighten the 10 bolts in several steps in the sequence shown in the illustration.

      Torque:
      74 N*m  { 755 kgf*cm, 55 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here