CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CAMSHAFT POSITION SENSOR (w/o Dual VVT-i)


    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

    2. Install the camshaft position sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • When reusing the camshaft position sensor, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

    3. Connect the camshaft position sensor connector.

  2. INSTALL CAMSHAFT POSITION SENSOR (w/ Dual VVT-i)


    1. for Intake Side:


      1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      2. Install the camshaft position sensor with the bolt.

        Torque:
        9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

        Note


        • When reusing the camshaft position sensor, inspect the O-ring.

        • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

      3. Connect the camshaft position sensor connector.

    2. for Exhaust Side:


      1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      2. Install the camshaft position sensor with the bolt.

        Torque:
        9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

        Note


        • When reusing the camshaft position sensor, inspect the O-ring.

        • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

      3. Connect the camshaft position sensor connector.

  3. INSTALL INTAKE AIR CONNECTOR (w/ Dual VVT-i)


    1. Temporarily install the intake air connector to the throttle body assembly.

    2. Connect the vacuum hose to the intake air connector.

    3. A003COPE01

      Connect the No. 2 PCV hose to the cylinder head cover sub-assembly, and slide the clamp to secure the hose.

    4. Install the intake air connector with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    5. Tighten the 2 hose clamps.

      Torque:
      for clamp A
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY (w/ Dual VVT-i)


    1. Install the engine service hole sub cover with the 5 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  5. INSTALL FRONT DOOR SCUFF PLATE RH (w/ Dual VVT-i)

  6. INSTALL FRONT SEAT ASSEMBLY RH (w/ Dual VVT-i)

    Click here