CANISTER INSPECTION


  1. INSPECT CHARCOAL CANISTER ASSEMBLY


    1. Check the appearance.


      1. A003GT2

        Visually check the charcoal canister for cracks or damage.

        If necessary, replace the charcoal canister.

    2. Check the charcoal canister filter.


      1. A003F0XE01

        Remove the charcoal canister filter.

      2. A003E5XE01

        Visually check that the charcoal canister filter is not excessively damaged or dirty.

        If necessary, replace the charcoal canister.

    3. Check the ventilation.


      1. A003EPYE01

        Blow air (4.7 kPa (48 gf/cm2, 0.68 psi)) into port A, then check that the air flows from ports B and C.

        If the ventilation is not as specified, replace the charcoal canister.

    4. Clean the filter in canister.


      1. A003H7FE01

        Clean the filter by blowing (19.6 kpa (0.2 kgf/cm2, 2.8 psi)) compressed air into port B while holding port A closed.

        Note


        • Do not attempt to wash the canister.

        • No activated carbon should come out.

    5. Install the charcoal canister filter.