EXHAUST GAS TEMPERATURE SENSOR (for Front) REMOVAL


  1. REMOVE SEAT TRACK COVER LH


    1. A003B84

      Using a clip remover, remove the clip.

    2. Detach the claw and remove the seat track cover LH.

  2. REMOVE FRONT SEAT ASSEMBLY RH


    1. A003GD3

      Move the front seat assembly fully forward.

    2. Remove the 2 bolts on the rear side of the seat.

    3. Move the front seat assembly to the rearmost position.

    4. Remove the 2 bolts on the front side of the seat.

    5. Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.

    6. Disconnect the front seat inner belt assembly connector.

    7. Remove the front seat assembly.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

  4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Fold back the floor carpet.

    2. Remove the 5 bolts and engine service hole sub cover sub-assembly.

  5. REMOVE ENGINE ASSEMBLY

    Tech Tips

    Perform this procedure only when removal or installation of the No. 3 exhaust gas temperature sensor.

    Click here

  6. REMOVE EXHAUST GAS TEMPERATURE SENSOR

    CAUTION:

    To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


    1. A003CY1

      Disconnect the 3 connectors from the 3 exhaust gas temperature sensors.

    2. A003GZI

      Remove the nut and disconnect the No. 3 exhaust gas temperature sensor from the No. 1 vacuum pipe.

    3. A003ENE

      Remove the bolt and open the clamp of the pipe clamp.

    4. Detach the 3 connectors from the pipe clamp.

    5. A003CZ4

      Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.

    6. A003AL6

      Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.

    7. A003DXU

      Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.