POWER WINDOW REGULATOR MOTOR(for Front Door) INSPECTION

PROCEDURE

1. INSPECT FRONT POWER WINDOW REGULATOR ASSEMBLY LH

   
   
   1. 

      *1	UP
      *2	DOWN

      Check that the window regulator moves smoothly as follows.

      Note

      Do not apply positive (+) battery voltage to any terminal other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

      OK

      Measurement Condition Specified Condition Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP). Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second. Arm of window regulator rotates counterclockwise (Up) Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN). Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second. Arm of window regulator rotates clockwise (Down)

      
      

      • If the result is not as specified, replace the regulator.

      CAUTION:

      Reset the door window regulator (initialize the pulse sensor) after installing the door window regulator to the door.

2. INSPECT FRONT POWER WINDOW REGULATOR ASSEMBLY RH

   
   
   1. 

      *1	UP
      *2	DOWN

      Check that the window regulator moves smoothly as follows.

      Note

      Do not apply positive (+) battery voltage to any terminal other then terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

      OK

      Measurement Condition Specified Condition Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP). Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second. Arm of window regulator rotates clockwise (Up) Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN). Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second. Arm of window regulator rotates counterclockwise (Down)

      
      

      • If the result is not as specified, replace the regulator.

      CAUTION:

      Reset the door window regulator (initialize the pulse sensor) after installing the door window regulator to the door.