CONDENSER INSTALLATION

PROCEDURE


  1. INSTALL CONDENSER ASSEMBLY WITH RECEIVER


    1. A004QN0

      Install the condenser assembly with receiver as shown in the illustration.

      Tech Tips

      If the condenser is replaced with a new one, add compressor oil to a new condenser.

      Capacity
      40 cc (1.4 fl.oz)
      Compressor oil
      ND-OIL 8 or equivalent

  2. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY


    1. A004NST

      Install the upper radiator support sub-assembly LH and upper radiator support sub-assembly RH with the 4 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  3. INSTALL UPPER RADIATOR SUPPORT


    1. A004REY

      Install the 2 upper radiator supports with the 2 bolts.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

  4. CONNECT SUCTION PIPE SUB-ASSEMBLY

    A004RIA

    1. Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.

      Compressor oil
      ND-OIL 8 or equivalent

    3. Install the O-ring to the suction pipe sub-accessory assembly.

    4. Connect the suction pipe sub-assembly to the cooler condenser assembly with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  5. CONNECT DISCHARGE HOSE SUB-ASSEMBLY

    A004OGQ

    1. Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

      Compressor oil
      ND-OIL 8 or equivalent

    3. Install the O-ring to the discharge hose sub-assembly.

    4. Connect the discharge hose sub-assembly to the cooler condenser assembly with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSTALL RADIATOR GRILLE BRACKET


    1. A004TUH

      Install the radiator grille bracket with the 2 bolts and nut.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  7. CHARGE REFRIGERANT

    Click here

  8. INSTALL OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)

    Click here

  9. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  10. INSTALL FRONT BUMPER COVER


    1. Install the front bumper cover Click here.

  11. WARM UP ENGINE

    Click here

  12. CHECK FOR REFRIGERANT GAS LEAK

    Click here