AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) PRECAUTION


  1. PRECAUTIONS WHEN USING INTELLIGENT TESTER


    1. When using the intelligent tester to troubleshoot the CAN communication line or LIN communication line:

      Connect the intelligent tester to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

    2. After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned to ON.

  2. IF ANY OF FOLLOWING CONDITIONS ARE MET, KEEP ENGINE IDLING WITH AIR CONDITIONING SWITCH ON (ENGINE SPEED AT LESS THAN 2000 RPM) FOR AT LEAST 2 MINUTES


    • Refrigerant gas has been refilled or parts of the air conditioning system have been replaced.

    • The engine has not been started for a long time.

    Note

    If the engine speed is more than 2000 rpm, the cooler compressor assembly may be damaged.

  3. DO NOT HANDLE REFRIGERANT IN AN ENCLOSED AREA OR NEAR AN OPEN FLAME

    A004MM0

  4. ALWAYS WEAR EYE PROTECTION

  5. BE CAREFUL NOT TO GET LIQUID REFRIGERANT IN YOUR EYES OR ON YOUR SKIN

    A004NCI

    If liquid refrigerant gets in your eyes or on your skin:


    1. Wash the area with lots of cold water.

      CAUTION:

      Do not rub your eyes or skin.

    2. Apply clean petroleum jelly to the skin.

    3. Go immediately to a hospital or see a physician for professional treatment.

  6. NEVER HEAT CONTAINER OR EXPOSE IT TO OPEN FLAME

  7. BE CAREFUL NOT TO DROP CONTAINER OR APPLY PHYSICAL SHOCKS TO IT

  8. DO NOT OPERATE COMPRESSOR WITH INSUFFICIENT REFRIGERANT IN REFRIGERANT SYSTEM

    If there is not enough refrigerant in the refrigerant system, oil lubrication will be insufficient and compressor burnout may occur. Necessary care should be taken to avoid this.

  9. DO NOT OPEN HIGH PRESSURE MANIFOLD VALVE WHILE COMPRESSOR IS OPERATING

    A004Q3QE54
    *1 Incorrect
    *2 Correct

    Open and close only the low pressure valve. Opening and closing the high pressure valve could cause the charging cylinder to rupture.

  10. BE CAREFUL NOT TO OVERCHARGE SYSTEM WITH REFRIGERANT

    If the refrigerant is overcharged, it causes problems such as insufficient cooling, poor fuel economy and engine overheating.

  11. DO NOT OPERATE ENGINE AND COOLER COMPRESSOR ASSEMBLY WITHOUT REFRIGERANT

    Note

    This may damage the inside of the cooler compressor assembly.

  12. IGNITION SWITCH EXPRESSIONS

    Tech Tips

    The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression Ignition Switch (position) Engine Switch (condition)
    Ignition Switch off Off Off
    Ignition Switch ACC ACC On (ACC)
    Ignition Switch ON ON On (IG)
    Engine Start START Start