FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  4. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  5. REMOVE LOWER CENTER PILLAR GARNISH LH

    Click here

  6. REMOVE LAP BELT OUTER ANCHOR COVER

    Click here

  7. REMOVE CENTER PILLAR GARNISH LH

    Click here

  8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    A004TGY

    1. Remove the nut and shoulder anchor.

    2. A004OU1

      w/o Pre-crash Safety System:

      Disconnect the pretensioner connector as shown in the illustration.

    3. A004U2T

      w/ Pre-crash Safety System:


      1. Disconnect the pretensioner connector as shown in the illustration.

      2. Disconnect the connector.

    4. A004OVZ

      Remove the 2 bolts and seat belt.

  9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    A004QDE

    1. Remove the 2 bolts and adjuster.