LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    1. A004RDT

      Pass the pump of the lumbar support adjuster assembly LH through the hole in the seatback spring as shown in the illustration.

    2. Attach the 4 hooks.

      A004SGJ

    3. Fold down the backing sheet and insert it into the openings as shown in the illustration.

      A004U4TE02
      Text in Illustration
      *1 Backing Sheet *2 Opening

    4. Attach the 2 hooks.

    5. Attach the 2 hooks as shown in the illustration.

      A004PIT
    6. A004RDD

      Install 2 new cable ties.

    7. Return the wire harness to its original position as shown in the illustration.

      A004O1X
    8. A004U7F

      Attach the 8 hooks to install the seatback spring.

    9. A004MN1

      Connect the connector.

  2. INSTALL SEPARATE TYPE FRONT SEATBACK PAD

    Click here

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  4. INSTALL SEPARATE TYPE SEAT CUSHION COVER WITH PAD

    Click here

  5. INSTALL FRONT OUTER SEAT CUSHION BRACKET


    1. A004RR6

      Attach the 2 claws to install the front outer seat cushion bracket with connector link.

    2. A004OURE01
      Text in Illustration
      *1 Connector Link

      Connect the connector link and install the clip.

  6. INSTALL RECLINING CONTROL LEVER LH

    Click here

  7. INSTALL FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  8. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH

    Click here

  9. INSTALL SEAT SLIDE POSITION SENSOR PROTECTOR

    Click here

  10. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  11. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  12. INSTALL VERTICAL ADJUSTING HANDLE LH

    Click here

  13. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP

    Click here

  14. INSTALL FRONT SEAT ASSEMBLY

    Click here

  15. CHECK SRS WARNING LIGHT

    Click here

  16. INSPECT FRONT SEAT ASSEMBLY


    1. Check the lumbar support operation.


      1. Operate the lumbar front power seat switch and check that the lumbar support moves in both directions.

    2. w/ Seat Heater System:

      Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.