LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE LH

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  6. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

    Click here

  7. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

    Click here

  8. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  9. REMOVE RECLINING CONTROL LEVER LH

    Click here

  10. REMOVE FRONT OUTER SEAT CUSHION BRACKET


    1. A004NSJE02
      Text in Illustration
      *1 Connector Link

      Remove the clip and disconnect the connector link.

    2. A004QY3E02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 2 claws and remove the front outer seat cushion bracket with connector link.

      Tech Tips

      Tape the screwdriver tip before use.

  11. REMOVE SEPARATE TYPE SEAT CUSHION COVER WITH PAD

    Click here

  12. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  13. REMOVE SEPARATE TYPE FRONT SEATBACK PAD

    Click here

  14. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    1. A004MN1

      Disconnect the connector.

    2. A004U7F

      Detach the 8 hooks and remove the seatback spring.

    3. Pull the wire harness and disconnect it from the backing sheet as shown in the illustration.

      A004RRLE02
      Text in Illustration
      *1 Backing Sheet - -
    4. A004RDD

      Cut off the 2 cable ties.

    5. Detach the 2 hooks as shown in the illustration.

      A004PN5

    6. Detach the 2 hooks.

      A004UCCE02
      Text in Illustration
      *1 Opening - -

    7. Pull out the backing sheet from the openings and fold it up as shown in the illustration.

    8. Detach the 4 hooks.

      A004PJR
    9. A004NCB

      Detach the 4 hooks.

    10. Pass the pump of the lumbar support adjuster assembly LH through the hole in the seatback spring as shown in the illustration and remove the lumbar support adjuster assembly LH.