FRONT POWER SEAT MOTOR ASSEMBLY(for Front Vertical) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER SEAT MOTOR ASSEMBLY (for Front Vertical)


    1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm rivet into the nose piece.

    2. A004RI1E01
      Text in Illustration
      *1 Air Riveter

      Using the air riveter or hand riveter, install the power seat motor assembly with 2 new rivets.

      Tech Tips

      If the rivet cannot be cut, pull it once and cut it.

    3. A004NGQE01
      Text in Illustration
      *1 Air Riveter

      Using the air riveter or hand riveter, install the power seat motor assembly with bracket with 2 new rivets.

      Tech Tips

      If the rivet cannot be cut, pull it once and cut it.

    4. A004RZQE01
      Text in Illustration
      *1 Air Riveter

      Using the air riveter or hand riveter, install 4 new rivets.

      Tech Tips

      If the rivet cannot be cut, pull it once and cut it.

    5. A004U2B

      Using a 6 mm socket hexagon wrench, install the bolt.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }
    6. A004NOJ

      Install the shield bracket with the 3 screws.

    7. Connect the connector.

  2. INSTALL SEAT CUSHION COVER WITH PAD

    Click here

  3. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH

    Click here

  4. INSTALL FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  5. INSTALL FRONT POWER SEAT SWITCH

    Click here

  6. INSTALL FRONT SEAT CUSHION SHIELD LH WITH FRONT SEAT INNER NO. 1 CUSHION SHIELD

    Click here

  7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  8. INSTALL RECLINING POWER SEAT SWITCH KNOB

    Click here

  9. INSTALL FRONT SEAT ASSEMBLY

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here

  11. INSPECT FRONT SEAT ASSEMBLY


    1. Check the power seat operation Click here.

    2. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.