LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE RECLINING POWER SEAT SWITCH KNOB

    Click here

  3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD LH WITH FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

    Click here

  5. REMOVE FRONT POWER SEAT SWITCH LH

    Click here

  6. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

    Click here

  7. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

    Click here

  8. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Click here

  10. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  11. REMOVE SEPARATE TYPE FRONT SEATBACK PAD

    Click here

  12. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    1. A004MN1

      Disconnect the connector.

    2. A004U7F

      Detach the 8 hooks and remove the seatback spring.

    3. Pull the wire harness and disconnect it from the backing sheet as shown in the illustration.

      A004RRLE02
      Text in Illustration
      *1 Backing Sheet - -
    4. A004RDD

      Cut off the 2 cable ties.

    5. Detach the 2 hooks as shown in the illustration.

      A004PN5

    6. Detach the 2 hooks.

      A004UCCE02
      Text in Illustration
      *1 Opening - -

    7. Pull out the backing sheet from the openings and fold it up as shown in the illustration.

    8. Detach the 4 hooks.

      A004PJR
    9. A004NCB

      Detach the 4 hooks.

    10. Pass the pump of the lumbar support adjuster assembly LH through the hole in the seatback spring as shown in the illustration and remove the lumbar support adjuster assembly LH.