FRONT POWER SEAT MOTOR ASSEMBLY(for Reclining) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER SEAT MOTOR ASSEMBLY (for Reclining)


    1. A004UA0

      Remove the 2 holders together with the 2 inner reclining rods from the reclining rod.

    2. A004RGS

      Remove the inner reclining rod and push nut from the holder.

    3. A004NRP

      Remove the inner reclining rod and push nut from the holder.

    4. A004R5D

      Install the 2 holders to the reclining rod.

    5. A004UEG

      Install the push nut to the holder.

      Note

      Make sure the direction of the push nut is as shown in the illustration.

    6. A004OSJ

      Install the push nut to the holder.

      Note

      Make sure the direction of the push nut is as shown in the illustration.

    7. Clean the threads of the bolt for the power seat motor assembly with non-residue solvent.

    8. Apply adhesive to the threads of the bolt for the power seat motor assembly.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    9. A004U6V

      Temporarily install the power seat motor assembly with the bolt.

    10. A004OZZ

      Push in the inner reclining rod as shown in the illustration.

    11. A004NM5

      Push in the inner reclining rod as shown in the illustration.

    12. A004MMT

      Push in the 2 inner reclining rods in alternating passes to install them

      Note

      Make sure that the holder does not interfere with the power seat motor assembly or front seatback frame.

    13. Tighten the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    14. A004QIW

      Attach the 8 hooks to install the seatback spring.

    15. A004QQF

      for Driver Side:

      Connect the 2 connectors.

    16. A004U71

      for Front Passenger Side:

      Connect the connector.

  2. INSTALL SEPARATE TYPE FRONT SEATBACK PAD


    1. A004TK1

      Install the separate type front seatback pad.

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  4. INSTALL FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  5. INSTALL FRONT SEAT CUSHION SHIELD LH WITH FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

    Click here

  6. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  7. INSTALL RECLINING POWER SEAT SWITCH KNOB

    Click here

  8. INSTALL FRONT SEAT ASSEMBLY

    Click here

  9. CHECK SRS WARNING LIGHT

    Click here

  10. INSPECT FRONT SEAT ASSEMBLY


    1. Check the power seat operation Click here.

    2. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.