FRONT SEAT ASSEMBLY(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT SEAT ASSEMBLY


    1. A004TP8

      Install the front seat assembly as shown in the illustration.

      Note


      • Be careful not to damage the vehicle body.

      • Make sure the seatback does not contact the shift lever knob.

      • Make sure the power seat switch knob does not contact the center pillar.

      Tech Tips

      Install the front seat assembly through the door frame so that it passes under the steering wheel.

    2. Connect the connectors under the front seat assembly.

    3. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the power seat switch (slide switch) to move the front seat assembly to the foremost position.

    6. A004U1DE02

      Tighten the 2 bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    7. Operate the power seat switch (slide switch) to move the front seat assembly to the rearmost position.

    8. A004TT2E02

      Tighten the 2 bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER


    1. A004TTY

      Attach the 4 claws to install the front seat outer track bracket cover.

  3. INSTALL FRONT SEAT INNER TRACK BRACKET COVER


    1. A004RGV

      Attach the 4 claws to install the front seat inner track bracket cover.

  4. INSTALL FRONT SEAT REAR OUTER TRACK COVER


    1. Operate the power seat switch (slide switch) to move the front seat assembly to the foremost position.

    2. A004T5T

      Attach the 2 claws to install the front seat rear outer track cover.

  5. INSTALL FRONT SEAT REAR INNER TRACK COVER


    1. A004ROS

      Attach the 2 claws to install the front seat rear inner track cover.

  6. CHECK SRS WARNING LIGHT

    Click here

  7. INSPECT FRONT SEAT ASSEMBLY


    1. Check the power seat operation Click here.

    2. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.