PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A47

DTC Code DTC Name
C1A47 Steering Angle Sensor

DESCRIPTION

The pre-crash safety city sensor receives steering rotation angle information from the spiral with sensor cable sub-assembly (steering angle sensor). When the pre-crash safety city sensor detects a steering sensor malfunction, C1A47 is output.

DTC Code DTC Detection Condition Trouble Area
C1A47 When the vehicle speed is 50 km/h (31 mph) or more, the pre-crash safety city sensor continuously receives a steering angle sensor malfunction for 1 second or more.

  • Vehicle stability control system

  • Spiral with sensor cable sub-assembly

  • Pre-crash safety city sensor

CAUTION / NOTICE / HINT

Note


  • When replacing the pre-crash safety city sensor, replace it with a new one. If an ECU which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be output.

  • When replacing the pre-crash safety city sensor with a new one, or performing removal, installation or replacement of the windshield glass, always perform "Recognition Camera/ Target Position Memory" and "Beam Axis Learning".

    Perform adjustment with either "ONE TIME RECOGNITION" or "SEQUENTIAL RECOGNITION".


  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed to troubleshooting Click here.

PROCEDURE


  1. CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

    5. Check for DTCs Click here.

      Result
      Result Proceed to
      Vehicle stability control system DTCs are not output A
      Vehicle stability control system DTCs are output B

    B

    GO TO VEHICLE STABILITY CONTROL SYSTEM Click here

    A

  2. CHECK FOR DTCs


    1. Clear the DTCs Click here.

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1A47 is not output A
      DTC C1A47 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

  3. REPLACE PRE-CRASH SAFETY CITY SENSOR


    1. Replace the pre-crash safety city sensor with a new one Click here.


    NEXT

  4. CHECK FOR DTCs


    1. Clear the DTCs Click here.

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1A47 is not output A
      DTC C1A47 is output B

    A

    END (PRE-CRASH SAFETY CITY SENSOR WAS DEFECTIVE)

    B

    REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY Click here