SIDE AIRBAG SENSOR(for Center Pillar) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

  4. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  6. REMOVE LOWER CENTER PILLAR GARNISH LH

    Click here

  7. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


    1. A004MS9

      Disconnect the connector.

    2. Remove the bolt and side airbag sensor.