KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

PROCEDURE


  1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A004O98E01
      Text in Illustration
      *a Connector Lock

      Connect the airbag connector and lock the connector lock.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    4. Attach the 2 claws to connect the DLC3.

    5. Attach the 7 claws to install the lower No. 1 instrument panel airbag assembly.

    6. Install the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL LOWER STEERING COLUMN COVER

    Click here

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.