KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. 

      Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

   2. Attach the 2 claws to install the DLC3.

   3. Attach the 7 claws to install the instrument panel airbag.

   4. Install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

2. INSTALL LOWER STEERING COLUMN COVER

   
   

   1. Install the lower steering column cover.

      for Manual Tilt and Manual Telescopic Steering Column: Click here

      for Power Tilt and Power Telescopic Steering Column: Click here

3. INSTALL LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

   Click here

4. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

5. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

8. CHECK SRS WARNING LIGHT

   
   

   1. Check the SRS warning light Click here.