KNEE AIRBAG ASSEMBLY(for Driver Side) REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  3. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  4. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  5. REMOVE LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

    Click here

  6. REMOVE LOWER STEERING COLUMN COVER


    1. Remove the lower steering column cover.

      for Manual Tilt and Manual Telescopic Steering Column: Click here

      for Power Tilt and Power Telescopic Steering Column: Click here

  7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. A004SQY

      Remove the 4 bolts.

    2. Detach the 7 claws and remove the instrument panel airbag.

    3. Detach the 2 claws and disconnect the DLC3.

    4. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.