BACK DOOR LOCK(for Wagon) INSPECTION

PROCEDURE


  1. INSPECT BACK DOOR LOCK ASSEMBLY


    1. A004PLME01
      *1 Component without harness connected: (Back Door Lock)
      *2 Closed
      *3 Open

      Check operation of the door lock motor.


      1. Move the door lock to the close position.

      2. Apply battery voltage to the door lock motor and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (ACT-)

        Battery negative (-) → 2 (ACT+)

        		 Open

        If the result is not specified, replace the back door lock assembly.

    2. A004PLME03
      *1 Component without harness connected: (Back Door Lock)
      *2 Closed
      *3 Open

      Check operation of the door courtesy switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ACT-) - 3 (D+) Close 10 kΩ or higher
        1 (ACT-) - 3 (D+) Open Below 1 Ω

        If the result is not specified, replace the back door lock assembly.