REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR LOCK ASSEMBLY LH

    Note


    • When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water intrusion in the connection. This may result in a malfunction of the rear door lock assembly.


    1. Apply MP grease to the sliding parts of the rear door lock assembly.

    2. Install a new door lock wiring harness seal to the rear door lock assembly.

    3. A004OEVE02
      *1 w/o Double Locking System:
      *2 w/ Double Locking System:

      Insert the rear door lock assembly into the rear door outside handle release plate, and set it to the rear door panel.

    4. Check sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

    5. Using a T30 "TORX" wrench, install the rear door lock assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }
    6. A004PI5

      Attach the clamp.

  4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  5. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  7. INSTALL REAR DOOR GLASS RUN LH

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. INSTALL REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

    Click here

  12. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  14. INSTALL ASSIST GRIP COVER LH

    Click here

  15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.