WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System) HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • The wireless door lock control system troubleshooting procedures are based on the premise that the following systems are operating normally. Check these systems first before troubleshooting the wireless door lock control system.


    • Power door lock control system

    • Luggage compartment door opener system (for Sedan)

  • Use these procedures to troubleshoot the wireless door lock control system.

  • *: Use the intelligent tester.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard Voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTCs.

      Click here

    3. Recheck for DTCs Click here. Based on the DTCs output above, try to force output of the same CAN communication system DTC, LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.

      Result
      Result Proceed to
      DTC is not output A
      CAN communication system DTC is output B
      LIN communication system DTC is output C
      Wireless door lock control system DTC is output D

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO LIN COMMUNICATION SYSTEM Click here

    D

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  4. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    B

    GO TO STEP 6 Click here

    A

  5. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check

      Click here

    2. Terminals of ECU

      Click here

    3. Data List / Active Test

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  6. REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  7. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END