NAVIGATION SYSTEM Data Signal Circuit between Stereo Jack Adapter and Extension Module

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation ECU via this circuit.

WIRING DIAGRAM

A004NW6E09
*a No. 1 Stereo Jack Adapter Assembly
*b Navigation ECU
*c Data Signal (USB Communication Line)

CAUTION / NOTICE / HINT

Note

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the D133 navigation ECU connector.

    2. Disconnect the D121 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D133-2 (US1-) - D121-2 (UDO-) Always Below 1 Ω
      D133-3 (US1+) - D121-3 (UDO+) Always Below 1 Ω
      D133-2 (US1-) - Body ground Always 10 kΩ or higher
      D133-3 (US1+) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR