LIGHTING SYSTEM Hazard Warning Switch Circuit

DESCRIPTION

The combination meter assembly receives a hazard warning signal switch information signal, and illuminates the turn signal lights.

WIRING DIAGRAM

A004PAJE04

CAUTION / NOTICE / HINT

Note

When replacing the combination meter assembly, make sure to replace it with a new one.

PROCEDURE


  1. READ VALUE USING GTS (HAZARD FLASHER SWITCH)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body or Chassis / Combination Meter / Data List.

    5. According to the display on the GTS, read the Data List.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Hazard Flasher Switch Hazard warning signal switch assembly / OFF or ON

      OFF: Hazard warning signal switch assembly off

      ON: Hazard warning signal switch assembly on

      		 -

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. Remove the hazard warning signal switch assembly Click here.

    2. Inspect the hazard warning signal switch assembly Click here.


    NG

    REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)


    1. Disconnect the D61 hazard warning signal switch assembly connector.

    2. Disconnect the D141 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D141-3 (HAZ) - D61-4 (TB) Always Below 1 Ω
      D61-1 (E) - Body ground Always Below 1 Ω
      D61-4 (TB) - Body ground Always 10 kΩ or higher

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR