LIGHTING SYSTEM OPERATION CHECK

FOLLOW ME HOME SYSTEM (w/ Automatic Light Control System)

1. Turn the ignition switch is off.

2. Turn the light control switch to the off or Auto position.

3. Pull the light control switch to flash the headlights once.

4. Check that the low beam headlights come on for approximately 30 seconds.

AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (w/ Automatic Light Control System)

1. Turn the ignition switch to ON.

2. Turn the light control switch to the AUTO position.

3. Cover the rain sensor.

4. Check that the taillights and low beam headlights come on.

5. Uncover the rain sensor.

6. Check that the low beam headlights and taillights go off.

LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK

1. When the headlights, front fog lights*1, rear fog lights*2, clearance lights, taillights and license plate lights are on:

   *1: w/ Front Fog Light

   *2: w/ Rear Fog Light

   
   

   1. Close the driver side door.

   2. Turn the ignition switch to ON.

   3. Turn the light control switch to the AUTO position.

   4. Turn the ignition switch off.

   5. Check that the headlights, front fog lights*1, rear fog lights*2, clearance lights, taillights and license plate lights turn off.

      *1: w/ Front Fog Light

      *2: w/ Rear Fog Light

2. When the headlights and front fog lights* are on:

   *: w/ Front Fog Light

   
   

   1. Close all the doors.

   2. Turn the ignition switch to ON.

   3. Turn the light control switch to the head position.

   4. Turn the ignition switch off.

   5. Check that the headlights and front fog lights* turn off.

      *: w/ Front Fog Light

3. w/ Front Fog Light:

   When the front fog lights are on:

   
   

   1. Close all the doors.

   2. Turn the ignition switch to ON.

   3. Turn the light control switch to the tail position.

   4. Turn the ignition switch off.

   5. Check that the front fog lights turn off.

AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK (w/ AFS)

1. Check that the initialization (determination of the initial position) of the headlight leveling motor (headlight unit) is performed when the ignition switch is turned to ON.

2. Check that the AFS OFF indicator in the combination meter assembly comes on for approximately 3 seconds when the ignition switch is turned to ON, and then goes off.

3. Check that the headlight moves when all of the following conditions are met: 1) the rear of the vehicle is moved up or down, 2) the engine is running, 3) the vehicle is stopped, and 4) the light control switch is in the head position.

   Note

   Make sure to change the vehicle height slowly.

DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK (w/ Daytime Running Light)

1. Headlight dimmer switch (light control switch) is in the off or AUTO position (and the low beam headlights are not turned on via the automatic light control system).

2. Start the engine.

3. The parking brake is released.

4. Check that the daytime running lights come on.

LANE CHANGE FLASHER SYSTEM OPERATION CHECK

1. Turn the ignition switch to ON.

2. Check that the turn signal light flashes a specified number of times when the turn signal switch is moved to the lane change position (it is not necessary to hold the switch).

3. While the turn signal light is flashing after the turn signal switch is moved to the lane change position (it is not necessary to hold the switch), check that the turn signal light turns off after the turn signal switch is moved in the opposite direction.

FRONT CORNERING LIGHT OPERATION CHECK (w/ Cornering Light)

1. When any of the following conditions is met with the ignition switch ON, low beam headlights illuminated (front fog lights off) and vehicle speed below 40 km/h (25 mph), the cornering light (fog light assembly) illuminates.

   
   

   • Left or right turn signal light is on (only illuminates on the side the turn signal light is on).

   • Steering wheel is turned left or right (illuminates on the side the steering wheel is turned).

   • Shift lever is in R (both fog light assemblies illuminate).