RAIN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL RAIN SENSOR TAPE

    Tech Tips

    The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.


    1. Clean the rain sensor sensing portion with a piece of cloth.

    2. A004R22E02

      Peel off the smaller release sheet, and then attach the rain sensor tape to the rain sensor sensing portion as shown in the illustration.

      Standard Clearance
      Area Measurement
      A 18.0 mm (0.709 in.)
      B 6.0 mm (0.236 in.)

      Tech Tips

      Use your fingers to push out any air bubbles from under the tape.

  2. INSTALL RAIN SENSOR


    1. Clean the windshield glass with a piece of cloth, etc.

      Note


      • Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

      • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

    2. When installing a new rain sensor or replacing the rain sensor tape:

      Peel off the release sheet.

      Note

      Do not touch the silicon coated surfaces.

    3. A004NBE

      Connect the connector.

      Note

      Do not touch the silicon coated or glass surfaces.

    4. A004MTG

      Attach the 2 claws to install the rain sensor.

      Note

      Make sure that there are no air bubbles between the silicon coated and windshield glass.

  3. INSTALL NO. 2 RAIN SENSOR COVER


    1. A004SDY

      Using a screwdriver, attach the 2 claws to install the No. 2 rain sensor cover.

  4. INSTALL NO. 1 RAIN SENSOR COVER


    1. A004SAV

      Attach the 3 claws to install the No. 1 rain sensor cover.

  5. INSTALL FRONT ROOF TOP GARNISH

    Click here