FRONT WIPER MOTOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WIPER ARM HEAD CAP


    1. A004MQP

      Using a screwdriver, remove the front wiper arm head cap.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for both front wiper arm head caps.

      Text in Illustration
      A004PF6 Protective Tape

  4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A004QV1

      Remove the nut and the front wiper arm and blade assembly LH.

  5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A004O83

      Remove the nut and the front wiper arm and blade assembly RH.

  6. REMOVE HOOD TO COWL TOP SEAL


    1. A004PDG

      Detach the 6 clips and 2 claws and remove the hood to cowl top seal.

  7. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A004PWV

      Remove the clip.

    2. Detach the 5 claws and 3 guides.

    3. A004PJK

      Detach the 5 claws and remove the cowl top ventilator louver RH.

  8. REMOVE COWL TOP VENTILATOR LOUVER LH


    1. A004S0I

      Remove the clip.

    2. Detach the 3 claws and 3 guides.

    3. A004MUM

      Detach the 5 claws and remove the cowl top ventilator louver LH.

  9. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL


    1. A004QDI

      Remove the No. 1 heater air duct splash shield seal.

  10. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL


    1. A004QDM

      Remove the No. 2 heater air duct splash shield seal.

  11. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY


    1. A004T37E02
      Text in Illustration
      *1 Wiper Cushion

      Disconnect the connector.

    2. Remove the 2 bolts.

    3. Detach the wiper cushion from the body and remove the wiper motor and link assembly in the direction indicated by the arrow in the illustration..