VEHICLE STABILITY CONTROL SYSTEM ABS Warning Light Remains ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

If any of the following is detected, the ABS warning light remains on:


Tech Tips

In some cases, the intelligent tester cannot be used when the skid control ECU is abnormal.

WIRING DIAGRAM

A004TPUE02

CAUTION / NOTICE / HINT

Note

When replacing the skid control ECU (brake actuator assembly), perform the engine variant learning Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to
      DTC is not output. A
      DTC is output. B

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

  2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED


    1. Check if the skid control ECU connector is securely connected.

      OK
      The connector is securely connected.

    NG

    CONNECT CONNECTOR TO ECU CORRECTLY

    OK

  3. CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)


    1. Turn the ignition switch off.

    2. Disconnect the skid control ECU connector.

    3. A004QXXE01
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Skid Control ECU)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A42-28 (IG1) - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (GND1, GND2 TERMINAL)


    1. Turn the ignition switch off.

    2. Disconnect the skid control ECU connector.

    3. A004QLDE02
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Skid Control ECU)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A42-4 (GND1) - Body ground Always Below 1 Ω
      A42-1 (GND2) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. INSPECT COMBINATION METER ASSEMBLY


    1. Perform the Active Test of the combination meter to check the ABS warning light using the intelligent tester Click here.

      OK
      The ABS warning light turns on or off in accordance with the intelligent tester operation.

      Tech Tips

      If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Click here.


    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    NG

    REPLACE COMBINATION METER ASSEMBLY Click here