TIRE PRESSURE WARNING RECEIVER(for Sedan) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR BENCH TYPE SEAT CUSHION ASSEMBLY

    Click here

  4. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  5. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

    Click here

  6. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  7. REMOVE NO. 1 ROOM PARTITION BOARD

    Click here

  8. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. A004O5E

      Disconnect the connector.

    2. Remove the bolt and the tire pressure warning ECU and receiver.