TIRE PRESSURE WARNING SYSTEM, Diagnostic DTC:C2198/98

DTC Code DTC Name
C2198/98 Initialization Switch (for Test Mode DTC)

DESCRIPTION

During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.

DTC No. DTC Detection Condition Trouble Area
C2198/98 Test mode procedure is performed.

  • Tire pressure warning reset switch

  • Harness or connector

  • Tire pressure warning ECU and receiver

WIRING DIAGRAM

A004QZ4E46

CAUTION / NOTICE / HINT

Note


  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

  • It is necessary to perform initialization (See page ) after registration Click here of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

PROCEDURE


  1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    1. Remove the tire pressure warning reset switch Click here.

    2. Inspect the tire pressure warning reset switch Click here.


    NG

    REPLACE TIRE PRESSURE WARNING RESET SWITCH Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)


    1. Disconnect the tire pressure warning reset switch D137 connector and the tire pressure warning ECU and receiver G61*1 or L1*2 connector.


      • *1: for Sedan

      • *2: for Wagon

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for Sedan
      Tester Connection Condition Specified Condition
      G61-7 (CLSW) - D137-1 (INT) Always Below 1 Ω
      G61-7 (CLSW) or D137-1 (INT) - Body ground Always 10 kΩ or higher
      D137-2 (E) - Body ground Always Below 1 Ω
      for Wagon
      Tester Connection Condition Specified Condition
      L1-7 (CLSW) - D137-1 (INT) Always Below 1 Ω
      L1-7 (CLSW) or D137-1 (INT) - Body ground Always 10 kΩ or higher
      D137-2 (E) - Body ground Always Below 1 Ω
      Result
      Result Proceed to
      OK (for Sedan) A
      OK (for Wagon) B
      NG C

    A

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER Click here

    B

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER Click here

    C

    REPAIR OR REPLACE HARNESS OR CONNECTOR