REAR UPPER ARM INSTALLATION

PROCEDURE


  1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

    A004S7B

    1. Temporarily install the rear upper control arm to the rear suspension member and rear axle carrier with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION

    Click here

  3. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

    A004O2U

    1. Using a jack and wooden block, raise the vehicle so that the rear No. 2 suspension arm assembly LH is at the standard vehicle height to apply load to the rear suspension.

    2. A004S7B

      Tighten the 2 bolts and 2 nuts of the upper control arm.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

      Note

      Since a stopper nut is used, tighten the bolt.

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT


    1. Inspect and adjust the rear wheel alignment Click here.