REAR LOWER ARM INSPECTION

PROCEDURE


  1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

    A004NAO

    1. Inspect the turning of the ball joint.


      1. Install the installation nut to the ball joint stud.

      2. Move the stud back and forth 5 times. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

        Standard turning torque
        T= 0.5 to 3.4 N*m (36 kgf*cm, 31 in.*lbf) or less

        If the turning torque is not within the specified range, replace the rear No. 1 suspension arm with a new one.

    2. Check the dust boots for cracks or grease leakage.