FRONT AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. REMOVE FRONT FLEXIBLE HOSE

    Click here

  3. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  4. REMOVE FRONT DISC

    Click here

  5. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    A004OE5

    1. Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

      Maximum looseness
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness more than the maximum, replace the front axle hub sub-assembly.

  6. INSPECT FRONT AXLE HUB RUNOUT

    A004P8R

    1. Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front hub bolts.

      Maximum runout
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the runout more than the maximum, replace the front axle hub sub-assembly.

  7. INSTALL FRONT DISC

    Click here

  8. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  9. INSTALL FRONT FLEXIBLE HOSE

    Click here

  10. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }